Campbell Hausfeld WL6502 Uživatelský manuál stáhnout pdf (Strana 5)

DRAIN TANK

With compressor shut off and pressure

released: Drain moisture from tank by

opening drain valve underneath tank

(See Figure 7).

CLEANING

Turn power OFF and clean dust and dirt

from motor, tank, air lines and pump

cooling fins.

IMPORTANT: Unit should be located as

far from spraying area as hose will

allow to prevent over-spray from

clogging air filter.

AIR FILTER

Check air filter to be sure it is clean. To

service a filter, remove the filter

housing cover. Remove filter and clean

in hot, soapy water (Paper filters cannot

be washed). Rinse and let dry. Replace

air filters that cannot be cleaned. Place

filter back in the housing base. Replace

cover.

LUBRICATION

This is an oilless type compressor

requiring no lubrication.

THERMAL OVERLOAD PROTECTOR

This

com-

pressor is equipped with an automatic

reset thermal overload protector which

will shut off motor if it becomes

overheated.

If thermal overload protector shuts

motor OFF frequently look for the

following causes:

1. Low voltage

2. Lack of proper ventilation

If the

thermal

overload protector is actuated, the motor

must be allowed to cool down before

start-up is possible. The motor will

automatically restart without warning if

left plugged into electrical outlet and

unit is turned on.

5

www.chpower.com

Maintenance

Disconnect power source

then release all pressure

from the system before

attempting to install, service, relocate

or perform any maintenance. Service

should be performed by an authorized

service representative.

The compressor should be checked

often for any visible problems and the

following maintenance procedures

should be performed each time the

compressor is used.

ASME SAFETY VALVE

Do not

remove or

attempt to adjust the safety valve!

Check the safety valve by performing

the following steps:

1. Plug the compressor in and run until

shut off pressure is reached (see

Operating Procedure).

2. Wearing safety glasses, pull the ring

on the safety valve to release

pressure from compressor tank. Use

your other hand to deflect fast-

moving air from being directed

toward your face.

3. The safety valve should

automatically close at approximately

40-50 psi. If the safety valve does not

allow air to be released when you

pull on the ring, or if it does not

close automatically, it MUST be

replaced.

TORQUE REQUIREMENTS

Connecting rod bolt . . . . . . . . 20 in. Ibs.

Compressor hd. bolts. . . 100-110 in. Ibs.

Motor bolts . . . . . . . . . . . . . . . 35 in. Ibs.

Mounting bolts . . . . . . . . . . . . 90 in. Ibs.

END OF OPERATION/STORAGE

1. Turn AUTO/OFF switch to the OFF

position.

2. Unplug power cord from wall outlet

and wrap around handle to prevent

damage when not in use.

3. Wearing safety glasses drain tank of

air by pulling the ring on the safety

valve. Use other hand to deflect fast

moving air from being directed

toward your face.

4. Drain tank of condensation by

opening drain valve on bottom of

tank. Tank pressure should be below

10 psi when draining tank.

5. Air hose should be disconnected

from compressor and hung open

ends down to allow any moisture to

drain.

6. Compressor and hose should be

stored in a cool, dry place.

Figure 7

Figure 6

Oilless Compressors

1 2 3 4 5 6 7 8 9 10 ... 23 24

Komentáře k této Příručce

Žádné komentáře